How to correctly fit the Arbortech TURBO Plane to your angle grinder

 

CAUTION: Always use the metal mounting flange of the grinder. The TURBO Plane or the plastic washers supplied with the TURBO Plane have to center on the ridge of the metal mounting flange. Do not put the TURBO Plane or the plastic washers on the spindle shaft without using the metal mounting flange.

Turbo Plane fitting instructions

Depending on the size of the spindle of your grinder, you may have to use the white plastic reduction washer in order to correctly center the TURBO Plane on the metal mounting flange.

M10 SPINDLE GRINDERS
STEP 1.  The plastic white washer has to centre on the ridge of the metal mounting flange. Push the washer down and make sure it centres on the ridge.

STEP 2. If you wish to raise the blade you can use the black spacer washers on top of the white reduction washer.

STEP 3. Use the lock nut with the ridge facing down. Ensure that the lock nut is engaging sufficient thread of the spindle and is level or below the top of the spindle shaft thread when tightened.

M14 or 5/8 SPINDLE GRINDERS

STEP 1.  The black plastic spacer washer has to center on the ridge of the metal mounting flange. (If no spacer washers are being used the TURBO Plane has to center on the ridge of the mounting flange)

STEP 2. If you wish to raise the blade you can use the black spacer washers.

STEP 3. If you have used the black spacer washers use the Lock Nut with the ridge facing up. Ensure that the lock nut is engaging sufficient thread of the spindle and is level or below the top of the spindle shaft thread when tightened.

 

Leave a Comment

*Required fields Please validate the required fields

*

*