Trade Blade Troubleshooting (Formerly known as The Tuff-Cut)

The Trade Blade fits most 4″ (100mm) and 4 1/2″ (115mm) angle grinders. However, when choosing an angle grinder to suit the blade, you should look for the following features:

  • A metal guard that can be rotated and fixed to 45 degrees
  • An auxiliary handle
  • The on/off switch positioned on the top or side
  • At least 550 Watts power
  • 16mm (5/8″) or 22mm &/*”) spindle size

Mount the Trade-Blade to the grinder in the centre of the metal guard, using the washers provided where appropriate. Ensure that the blade will be rotating such that it pulls away from the user when in use.

For more information on fitting instructions, please see the Instructions Manual section.

YES! We recommend you use the angle grinders handle for additional control and stability when using the Trade Blade.

The width of the Trade-Blade is cut, is 5mm ( 3/16 of an inch). The Trade-Blade’s cutting depth is 25mm (1″inch) depending on the clearance of your grinder.

No, the pro-guard was specifically designed to suit a four inch grinder. The Trade-Blade is ideally suited to a four and a half inch or five inch grinder.

If you cannot find the answer to your question above, please email our technical support team: [email protected]

X