What does my grinder need to fit the PCS?

The PCS fits most 4” (100mm) and 4 ½” (115mm) angle grinders. However, when choosing an angle grinder to suit the PCS, you should look for the following:
– An auxiliary handle
– On/Off switch to be positioned on the top or side
– 550 watts power, at a minimum
– Spindle thread of M14 (AUS and UK) |M14 (Europe) |5/8” (North America)
If you need an M10 adapter nut click here.

How do I properly fit the PCS on an angle grinder?

Please refer to the instructions manual provided.

How to avoid bouncing?

A lot of factors can influence how the PCS performs. Applying the correct cutting technique when using the Precision Ball Gouge and Precision Barrel cutter will ensure it runs smoothly on even the hardest woods.

For more information, click here.

When should I rotate the blades?

The PCS cutters should be rotated when it feels blunt and does not produce nice wood shavings.

Why is it grabbing or bumpy?

Check that the universal adaptor shaft is fully tightened to the base of the grinder’s spindle. Remove the backing flange before screwing the universal adaptor.

Cutting along the grain will result in the tearing of the wood. Cutting across the grain will result in a smoother cut with minimal tearing.

For more information, click here.

Can I use the PCS on a cordless grinder?

Yes, if the grinder is powerful enough and runs at a speed of 9000RPM – 12,000 max.

If you cannot find the answer to your question above, please email our technical support team: [email protected]

X